コンテンツメニュー

Pressure Drop Characteristics in the Spouted Bed (I)

Memoirs of the Faculty of Engineering, Yamaguchi University Volume 27 Issue 2 Page 235-248
published_at 1977
KJ00000156160.pdf
[fulltext] 1.46 MB
Title
二次元噴流層における流動化状態と圧力損失特性 (第 1 報)
Pressure Drop Characteristics in the Spouted Bed (I)
Creators Hayano Nobuo
Creators Yamanaka Hisato
Creators Jyotaki Tomosada
Source Identifiers
The granular beds in witch air flows are called 'fixed, fluidized and spouted' beds, respectively, according to the flowing pattern of the granules inside the vessel. Hitherto, it is said that fluidized and spouted beds are more effective than fixed beds for operation of the drying and agitation process of the gas-solid system. In this report, we call the granular layer which has the plate with many tiny holes at the bottom of the vessel a 'fluidized bed' in which air flows uniformly passing through the bed without the velocity distribution in the horizontal cross section. On the other hand, in the case of the 'spouted bed', there is a long slit at the bottom-center of the vessel and air rushes upwards from the slit into the bed just like the jet stream. Then, steep velocity distribution exists in the horizontal cross section inside the granular bed. As the inlet velocity of air increases the center part of the granular surface is raised gradually. Then, suddenly, eruption of the surface occurs. The dynamic behavior of particles inside the bed and the pressure drop across the bed have been treated by many investigators, but because of the complexity of the phenomena itself, widely applicable results are not yet presented up to this time. Especially, in the case of the spouted bed, we feel that the collection and analysis of the fundamental data are still insufficient. This time, we used as the experimental apparatus the square vessel with the long slit at the bottom (two-dimensional spouted bed) and as for the granules, rape-seed (1.4mmφ), nylon-chip (2mmφ×3mm : cylinder) and glass-bead (mean diameter : 250μ) were used. We obtained the following results with various experimental conditions. 1) It is realized that corse particles are easier to fluidized than finer particles in the case of the spouted bed. 2) In the fixed granular bed, the curve of ΔP_m&acd
Subjects
機械工学 ( Other)
Languages jpn
Resource Type departmental bulletin paper
Publishers 山口大学工学部
Date Issued 1977
File Version Version of Record
Access Rights open access
Relations
[ISSN]0372-7661
[NCID]AN00244228
Schools 工学部